Know how to use the welded wire mesh machine? Let us tell you step by step!
1. The welded wire mesh machine closes the power switch to supply power to the welded wire mesh machine.
2. Check whether the pulling net platform is the starting position, if it is the third step, if not, press the "forward" or "backward" key to adjust it to the correct position.
3. Turn the "welded mesh control switch" and "pull mesh control switch" boards to the off position.
4. Put in the diameter wire.
5. Press the "ON" button to start the spindle motor.
6. Rotate the "Speed" button to make the machine turn.
7. The machine rotates and lays down the first weft wire, first turn on the "welding net control" switch, then turn on the "pull net control" switch, the machine will automatically weld.
△Note: It is necessary to transfer the weft to the weft placement device in time!
8. After the welding is completed, the machine will automatically stop.
9. Take off the mesh and insert the diameter wire for the next piece of welded mesh.
10. Repeat steps 6-10. Work normally.
△Note: Before the power of the welded wire mesh machine is turned off, the drawing platform should return to the original drawing position.
